Appalachian Southern

I am not sure where all the time has gone since my last post. Just trying to get all the materials ready for my wiring panel has taken some time. I am centrally locating as many of my DCC components as possible to minimize the rats nest of wiring that tends to develop under a layout. This centralized panel gives ready access to DCC bus power, 12 volt DC for power supplies, and 120VAC for other needs.  All of my power districts will be centally managed here on this panel. All of the DS64 tortoise controlers will also be mounted here. As the layout grows, the panel will grow to accomodate the needed devices. I have about five additional feet in which the panel can grow.

In the photos below you can see the red and black terminal strips which distribute the DCC bus lines to the layout. The blue and black terminal blocks house the 12 volt DC power for the AX lines on the DS64 units.  The wiring channels have lids that will cover up all the wiring when I am done. This is the same way I used to wire machines, and it works good for the layout.  This wiring channel is 1″ square, but I likely should have purchased 1″ x 2″ to accommodate all of the wiring. This is going to be a tight fit for the amount of wires that will call these channels home.

The first locomotive will be running in  a few minutes! I am excited!  Oops, can’t run anything without some LocoNet cables. I guess I will go and make those!

DCC Central Control Panel

DS64s Mounted to the Control Panel

8 Conductor CAT3 Cable to the Remote Tortoise Machines

DCC Bus Line Distribution Terminal Blocks

Shelf Holds Power Supply and DCS200 Next to the Control Panel